The further wifi signals have to travel, the weaker they get. Routers receive signals, decode them and send the information invisibly to all of the electronic equipment in your home. If instead you want your repeater to have a separate network name, you can click Advanced and change the SSID and password there as seen in the below screenshot:Wireless networks use radio waves to communicate. The AirTies device has now copied the network name/SSID and password from the router. Wait for about 30 seconds after pairing for the router and repeater to come online.If you are seeing two local networks (one for 5 GHz and one for 2.4 GHz), select 5 GHz.If the coverage is poor where you placed the repeater, you will need to find a better location for it. When you see the list of available wireless networks, make sure the repeater gets a good signal from the router.Click on the Repeater tab and follow the instructions.In the browser (Chrome, Firefox, Microsoft Edge or similar), go to the address.Connect your device to a laptop with the supplied Ethernet cable.If you cannot find WPS on your router or the above procedure does not work: Setting up Air 4920 as a Repeater Using air4920.local Should you later change the SSID or password on the router, you will need to repeat this setup as described above. After pairing, wait for about 30 seconds for both the router and the repeater to come online.The device will now connect to the router and copy its network name/SSID and password from the 5 Ghz network. On the Air 4920: Hold the WPS button on the front of the device for 2 seconds.

It can also be called PBC, which stands for 'push-button connect'. On some devices, you must log in and start WPS from the web interface.This will usually take about three minutes. Wait until the power symbol glows in white and the other LEDs flash in green. Connect the access point to power and turn it on.Unpack the device and remove all the protective plastic.Setting up the Air 4920 as a Repeater Using WPS This is one of the most common mistakes made with wireless repeaters.Ī repeater that has a weak signal from the router will cause poor performance and can ruin the network for everyone. Take care to select a location where the repeater itself receives a strong signal from the router!

How to Set up the AirTies Air 4920 as a Repeater Before You Startįind the place in your home where you want to extend your coverage. The devices included in an AirTies home pack are set up to be in the same mesh network and will not work as repeaters.

Home wifi booster daisy chain